Setting Mode - AEG FAVORIT 65020 VI Notice D'utilisation

SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation the display shows 2
horizontal status bars.
If the control panel shows other condi-
tions, press RESET until the appliance is
in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode.
3. Set the programme.
• The related programme number
flashes in the display.
4. If you want, you can set the options.
5. Close the appliance door. The pro-
gramme starts.
• If you open the door, the display
shows the programme duration that
decreases with steps of 1 minute.
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button again and
again until the display shows the delay
time you want to set (from 1 to 24
hours).
• The delay time flashes in the dis-
play.
• The delay indicator is on.
3. Close the appliance door. The count-
down starts.
• If you open the door, the display
shows the countdown of the delay
start that decreases with steps of 1
hour.
When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while
the countdown operates
Press RESET until the display shows 2 hor-
izontal status bars.
When you cancel a delay start, the
appliance goes back to setting
mode. You have to set the pro-
gramme again.
Cancelling the programme
Press RESET until the display shows 2 hor-
izontal status bars.
Make sure that there is detergent
in the detergent dispenser before
you start a new programme.
At the end of the programme
When the programme is completed, an
intermittent acoustic signal operates. The
display shows 0 and the end indicator
comes on.
1. Press the on/off button to deactivate
the appliance.
2. Close the water tap.
If you do not press the on/off but-
ton, the AUTO OFF device auto-
matically deactivates the appli-
ance after some minutes. This
helps to decrease the energy con-
sumption.
• Let the dishes become cold be-
fore you remove them from the
appliance. Hot dishes can be
easily damaged.
• First remove the items from the
lower basket, then from the up-
per basket.
• There can be water on the sides
and on the door of the appli-
ance. Stainless steel becomes
cool more quickly than the
dishes.
ENGLISH
35