Slendertone ReVise S5 Mode D'emploi page 10

USING THE TRIGGER
If you wish to vary the pre-set contraction-
relaxation cycle, you can use the Trigger to
control the length of a contraction. Once a
contraction has reached its peak, press and
hold the Trigger button (Fig. a) to maintain
that contraction for as long as you wish. Once
you release the Trigger, the unit will enter the
relaxation cycle.
:
IMPORTANT
You should never hold the Trigger for an excessive length of time and
should always ensure that you have sufficient relaxation periods. If
you hold the Trigger for too long without allowing your muscles to
relax sufficiently, the exercise can become gradually less effective,
as the muscles can fatigue quickly.
10
Fig. a
FINISHING YOUR SESSION
The session will stop automatically at the end of
each program's pre-set treatment time. However,
to switch off your unit at any time during a
session, press and hold the on/off button for
two seconds (Fig. b). Remove the GelPads and
replace them on their protective liners. You may
now exercise another area of your body, or you
can simply store your unit in the pouch provided
until your next session.
:
NOTE
You should only do one session per day on any
single body area.
English
Fig. b
www.slendertone.com