KINTERA KCO-1-N Manuel D'installation Et Mode D'emploi page 8

INSTALLATION OF RESTRAINT (Only for Ovens with Casters)
For an appliance equipped with casters, (1) the installation shall be made with a connector that complies
with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for
Moveable Gas Appliances CAN/CGA-6.16, and a quick-disconnect device that complies with the
Standard for Quick-Disconnect Devices for Use With Gas Fuel, ANSI Z21.41, or Quick Disconnect
Devices for Use with Gas Fuel, CAN1-6.9, (2) adequate means must be provided to limit the movement
of the appliance without depending on the connector and the quick disconnect device or its associated
piping to limit the appliance movement and (3) the restraining means should be attached to a frame member
on the back of the unit. Do not connect restraint to the any gas piping!
To avoid accidental gas disconnection and potential explosion: If disconnection of this restraint is
necessary to move the appliance for cleaning, etc., reconnect it when the appliance is moved to its
originally installed position
IMPORTANT SAFEGUARDS & SAFETY INSTRUCTIONS
When using gas cooking equipment, basic safety precautions should always be followed,
including the following:
The Convection Oven outside surfaces may become HOT after use. Use caution when touching the unit.

Never directly touch the cooking surface while the Convection Oven is on.

Always turn off the unit when not in use, servicing or adjusting any parts or attachments, and before cleaning.

Never leave the Convection Oven on overnight.

Do not operate any equipment with a damaged or leaking gas line, ignitor or valve, or if the unit is dropped or
damaged in any manner. Call for Service.

The use of attachments not recommended or sold by the manufacture may cause fire, injury or even death.

DO NOT US OUTDOORS.

Do not use this equipment for any use other that the use intended by the manufacturer.

Never use the Convection Oven as a heating source.

The Convection oven not does contain any user-serviceable parts. Dealer or recommended qualified technicians
should carry out repairs. Do not remove any components or service panels on this product.

Never bypass, alter, modify, or attach any unauthorized parts to this equipment. Doing so may create a hazard
and will void warranty.

We take every care to ensure that all products are safe. Steel cutting procedures used to manufacture these
items result in sharp edges. These sharp edges are removed to the best of our ability; however, we insist the
operator take care when in contact with this piece of equipment.

Always keep hands, hair, and clothing away from heating source.
Owner's/Installer Manual Rev 20180822
NOTICE
8
For Warranty Service Call 866-909-2855