Fire Hazard - KINTERA KCO-1-N Manuel D'installation Et Mode D'emploi

Checking For Gas Leaks: Using a gas leak detector or a soapy water solution is recommended for locating
gas leaks. Check entire piping system for leaks. DO NOT USE AN OPEN FLAME Matches, candle flame, or
other sources of ignition shall not be used for this purpose of checking for gas leaks
Exhaust Canopy: Cooking appliances inherently create a good deal of heat and smoke and should be
installed under an efficient exhaust hood with flame proof filters. A vertical distance of not less than four (4)
feet shall be provided between the top of the appliance and filters or any other combustible material.
FIRE DEATH HAZARD If you smell gas follow the instruction provided by the gas supplier.
Do not touch any electrical switch; do not try to light the burner; do not use a telephone within close
proximity.
NOTE: Smoke appearing on initial use of the appliance is normal. This is a result of the rust preventative
coating burning off. This will occur for at least fifteen (15) minutes during the first use or seasoning process.
Electric Connection: Before connecting the appliance to the outlet, check the following:

Voltage corresponds to the data written on the data plate.

Proper ground is present
The appliance, when installed, must be electrically grounded in accordance with local codes, or in the
absence of local codes, with the National Electrical Code, NFPA 70, or the Canadian Electrical Code,
CSA C22.2
COMMISSIONING: Commission of your new Convection Oven is of the utmost importance. Commissioning
is the thorough and methodical testing of the equipment, subsystems, and systems to ensure that the final
product functions properly and safely at the work site. By identifying any potential problems (i.e.: equipment
location, ventilation, local fire/electrical codes, installation, operator training, and certification) prior to
equipment being placed into service, costly outages and potential damages may be avoided.
FIRE, INJURY or DEATH HAZARD This appliance is for use in non-combustible
Do not install or use without legs. Use of this equipment without legs can cause the appliance to overheat
Improper installation, adjustment, alteration, service or maintenance can cause property
damage, injury or death. Read the installation, operating and maintenance instruction thoroughly before
This equipment mist be installed by a qualified installer in accordance with all federal, state and local
codes. Failure to install this equipment properly can result in injury or death.
Injuries or death can occur if this equipment is not used properly. To reduce risk of injury or death:

Keep the appliance area free and clear from combustibles

Do not obstruct the flow of combustion and ventilation air

Owner's/Installer Manual Rev 20180822
Do not spray controls or the outside of the appliance with liquids or cleaning agents

Let hot appliance cool before cleaning or moving

The appliance should only be used in a flat, level position

Do not operate unattended
location only

FIRE HAZARD

and cause a fire.
installing or servicing this equipment.
FIRE, INJURY or DEATH HAZARD
FIRE and INJURY or DEATH HAZARD
7
For Warranty Service Call 866-909-2855