Cleaning & Maintenance Instructions; Cleaning; Cleaning Stainless Steel Surfaces - KINTERA KCO-1-N Manuel D'installation Et Mode D'emploi

CLEANING & MAINTENANCE INSTRUCTIONS
FOR YOUR SAFETY, DISCONNECT THE ELECTRICAL POWER SUPPLY TO THE APPLIANCE BEFORE CLEANING. WHEN
CLEANING THE CONVECTION OVEN BLOWER WHEEL, BE SURE TO THE POWER SWITCH TO THE OFF POSITION.
1. Before cleaning, be sure the oven is cool and the power switch is in the off position.
2. Carefully clean daily the appliance to guarantee its proper operation and long life. Remove the
oven-interior racks and rack slide frames. (The rack slide frames are readily removable by merely
raising to disengage them from their sockets.) Wash the racks and rack slides in a sink with mild
detergent and warm water. Dry them thoroughly with a clean cloth.
3. Look to see if any foreign matter has accumulated in the blades of the blower wheel, (particles of
aluminum foil is very common of this.), the debris in the blower wheel will reduce the air flow
circulation inside the oven as a result will be poor back performance. Use a stiff brush to remove
debris and baked on matter from the blade of the blower wheel. Then was with soap and water.
4. Wash the interior surfaces with mild detergent and warm water. Rinse thoroughly with clean water.
For stubborn/baked on debris a commercial oven cleaner may be used. Do not use steel wool in the
interior of the oven, particles of the steel wool could be left behind and my contaminate food
product. Scotch-Brite® pads or alike that are non-metallic may be used.
MONTHLY CLEANING

Clean around the rear of the oven, especially the rear of the motor. Be sure the cooling vents are
not blocked with lint or debris. If so, use a stiff bristle brush to clean.

CLEANING STAINLESS STEEL SURFACES

On the stainless front or interiors, deposits of baked on splatter may be removed with any non-toxic
industrial stainless steel cleaner. Heat tint and heavy discoloration may be removed with any non-toxic
commercial oven cleaner.

Apply cleaners when the oven is cold. Always rub with the grain of the metal. Never in a circular
direction

To remove heat tint or darkened areas can be removed by the vigorous scouring in the direction of
the polish line or "grain" of the stainless. Using Scotch-Brite pads in combination with powdered
cleanser.
Owner's/Installer Manual Rev 20180822
12
For Warranty Service Call 866-909-2855