Diodetest - Klein Tools CL312 Manuel D'instructions

ENGLISH
OPERATING INSTRUCTIONS
CAPACITANCE
1. Insert RED test lead into VΩ jack
COM jack , and rotate function selector switch
4
Continuity/Resistance/Capacitance/Diode-Test
NOTE: The meter defaults to Continuity testing in this mode. Press
the "SELECT" button twice to enter Capacitance testing mode.
12
The Capacitance icon will appear on the display. The meter
should read 0 nF with test leads open.
2. Remove power from circuit.
3. Measure capacitance by connecting test leads across the
capacitor. The meter will auto-range to display the measurement
in the most appropriate range.
Black lead Red lead
14
, and BLACK test lead into
5
to the
2
setting.
OPERATING INSTRUCTIONS
DIODE TEST
1. Insert RED test lead into VΩ jack
COM jack , and rotate function selector switch
4
Continuity/Resistance/Capacitance/Diode-Test
NOTE: The meter defaults to Continuity testing in this mode. Press
the "SELECT" button three times to enter Diode testing mode.
12
The Diode icon will appear on the display.
2. Touch test leads to diode. A reading of 200-800mV on display
indicates forward bias, "OL" indicates reverse bias. An open
device will show "OL" in both polarities. A shorted device will
show approximately 0mV.
Black lead Red lead
FREQUENCY / DUTY-CYCLE
1. Insert RED test lead into VΩ jack
COM jack , and rotate function selector switch
4
Frequency/Duty-Cycle
NOTE: The meter defaults to Frequency testing in this mode. To enter
Duty-Cycle testing mode, press the "SELECT" button
that the appropriate icon (either Hz or % ) appears on the display.
2. Measure by connecting test leads across the circuit.
Black lead Red lead
, and BLACK test lead into
5
to the
2
setting.
and BLACK test lead into
5
to the
2
setting.
once. Ensure
12
15