Table des Matières
Publicité
1. Plug the coaxial cable of an external flat antenna into the
base on the rear top of the unit. In addition to normal
broadcast reception of VHF and UHF channels, connect
the attached coaxial connector to the antenna terminal on
the lower left side of the unit, and connect the cable to the
coaxial connector for S1~S41 reception.
2. With power applied to the system and the TV mode
selected, press TV/CATV on the remote control to select
the regular 69-channel Broadcast TV and the S41-Channel
Cable TV with on-screen display.
3. Press AUTO MEMORY; all channels in TV or CATV
mode are searched and tuned and the channels with
signals detected are automatically stored.
4. SKIP/SEARCH selects between SKIP and SEARCH
mode. In SKIP mode, the TV only stops on channels that
are programmed into memory when the CHANNEL
UP/DOWN buttons are used. When SKIP mode is off, the
TV will stop on all active channels.
5. To erase a TV channel, press ERASE/WRITE until
MANUAL MEMORY has erase displayed on the screen.
To store a TV channel, press this button until MANUAL
MEMORY has add displayed on the screen. The stored
channel numbers are displayed in green on the screen
while the non-stored channel numbers are in red.
K. Playing a Video Game
30
Publicité
Table des Matières
