Assembly And Adjustment - DeWalt DW849 Mode D'emploi

E N G L I S H
7.5
Voltage
115 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0

Assembly and adjustment

Prior to assembly and adjustment
@
always unplug the tool.
Mounting the side handle (fig. B)
● Screw the side handle (5) tightly into one of the
holes on either side of the tool.
Fitting and removing the backing pad (fig. C)
● Place the tool on a table, spindle up.
● Press the spindle lock (4) and turn the spindle
until the lock engages.
● Place the backing pad (6) onto the spindle.
● Screw the threaded flange (7) onto the spindle.
● Tighten the threaded flange.
● Release the spindle lock.
● To remove the backing pad, loosen the threaded
flange while the spindle lock is engaged.
Fitting the polishing bonnet (fig. D)
● Place the tool on a table, spindle up.
● Pull the polishing bonnet (8) over the backing
pad (6).
Instructions for use
● Always observe the safety instructions
@
and applicable regulations.
● Apply only a gentle pressure to the tool.
Do not exert side pressure on the
backing pad.
22
Cable length (m)
15 25 30 45
Amperes Cable rating (Amperes)
6 6 6 6
6 6 6 6 15
6 6 10 15 20
10 10 15 20 20
15 15 20 25 25
20 20 25 -
6 6 6 6
6 6 6 6
6 6 6 6 10
10 10 10 10 15
15 15 15 15 20
20 20 20 20 25
● Avoid overloading. Should the tool
60
6 10
Prior to operation:
15
● Be sure the threaded flange is mounted correctly.
20
● Make sure the pad rotates in the direction of the
25
arrows on the accessory and the tool.
-
● Make sure any dirt is washed off the workpiece
- -
surface.
6 6
6 6
Polishing (fig. A)
15
● Always use clean polishing bonnets.
15
● Evenly apply a required amount of polishing
20
paste over the polishing bonnet.
-
● Hold the polishing bonnet to the surface to be
polished and switch on the tool.
● Move the tool evenly over the surface, without
applying pressure.
● Switch off the machine before taking the tool
from the surface.
● Check your work at short intervals.
@
Switching on and off (fig. E)
● To run the tool, press the variable speed switch
(1). The pressure exerted on the variable speed
switch determines the tool speed.
● For continuous operation, also press the lock-
on button (2). The lock-on button works only in
full speed.
● Switching off: press the on/off switch again.
@
Speed control (fig. F)
The speed control dial (3) can be used for advance
setting of the required maximum tool speed.
● Turn the speed control dial (3) to the desired
position. The higher the number, the higher the
maximum tool speed.
become hot, let it run a few minutes
under no load condition.
High-speed rubbing action of the
polishing bonnet upon the workpiece
surface can build a static charge on the
metal portions of this tool resulting in
a static shock when touched.
Do not switch the tool on or off when
under load.