Assembly And Adjustments - DeWalt DWE4517 Guide D'utilisation

accessories running over rated speed can fly apart and cause injury.
Accessory ratings must always be above tool speed as shown on
tool nameplate.
ATTACHMENTS
Attachments designed specifically for this grinder can be
purchased through D WALT dealers and D
E
centers.
9" Type 27 guard
9" Type 28 guard
7" Type 27 guard
6" Type 11 Flaring cup guard with flange
4" Type 11 Flaring cup guard with flange
Type 11 Flaring cup wheel backing flange
Type 1 Flange set
7" Type 1 Guard
Grinding backing flange
Clamp nut
Wheel Wrench
Soft mount spindle protector

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Attaching the Side Handle (Fig. 3)
Attach the side handle (C) to one of the two
side handle ports (H).
Rotating the Gear Case
(Fig. 4)
WALT Factory Service
E
1. Remove guard and flanges from
tool.
D284939
2. Remove the four corner screws
D284938
attaching the gear case to motor
D284937
housing.
3. Separate the gear case from
D284936
motor housing, not more than
D284934
1/4" (6.35 mm), rotate the gear
608368-00
case head to desired position.
D284932
NOTE: If the gear case and motor housing become separated
by more than 1/4" (6.35 mm), the tool must be serviced and
D284931
re-assembled by a D
54339-00
serviced may cause brush, motor and bearing failure.
22191-00
4. Re-install screws to attach the gear case to the motor housing.
61820-01 Tighten screws to 20 in./lbs. torque. Overtightening could cause
screws to strip.
445928-01
OPERATION
WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
9
FIG. 3
FIG. 4
WALT service center. Failure to have the tool
E
C
H