Aqua Medic NR 1000 Mode D'emploi page 10

(the filter starts to smell badly). On the other side, zones with a rather high flow may arise where nitrate is
reduced only to nitrite. In each case, the conditions vary in the different zones of the filter and it is nearly
impossible to find its right working point.
These unpleasant effects are avoided by the construction of the Aqua Medic Nitratereductor. The recirculation
ensures a complete mixing and the same redox potential level in the whole filter. Zones with a very low redox
potential and the production of hydrogen sulfide are avoided. The redox potential can be used for controlling
the filter. The effectivity and reliability of the filter can be increased.
5. Connections
The following connections are located at the Nitratereductor's lid:
- Inlet (5): There, you can connect a 6/4 mm air tube. At the inflow, you find an adjustion valve to adjust the
flow rate. The best value is approx. 1 – 1.5 l/h (about 1 drop per second). The adjustion at the inflow causes
a delay until you can read the adjusted drop number at the drop counter (14) at the water outlet. The drop
counter is mounted inside the aquarium, close to the water level. If the flow rate is regulated in the outlet,
the valve may not be closed completely in order to allow produced nitrogen to escape. During the start phase
in the first weeks, the outlet valve should stay completely open. The inlet has an internal elongation that
prevents that gas enters the inlet tube.
- Feeding (4): Through this opening, you can inject denimar-powder with a syringe to enhance
denitrification. Dissolve the powder beforehand in some water. The valve has to be cleaned and closed after
every feeding.
- Redox electrode (17): Through this opening, you can put the pressure resistant ORP electrode with
standard thread (PG 13,5) Aqua Medic No: 220.18 (not included).
- Outflow to aquarium (14): There, you can connect an air tube 6/4 mm, preferably a black one to prevent
algae growth.
6. Set-Up
The Nitratereductor is a hermetically closed system. The produced gas (nitrogen and CO
the water outlet. For this reason, the outlet should never be completely closed, because an eventual
overpressure may escape through the water inlet and interrupt the inflow.
The Nitratereductor has to be placed in a way that the water can flow off either directly back into the aquarium
or into the filtration chamber. In a seawater aquarium, it is advantageous if the outflowing water is flowing into
the inlet of the protein skimmer or the trickling filter. In the protein skimmer, the water is saturated with oxygen
before it flows back into the aquarium.
- Inflow: The inflow into the reductor can be realized as a bypass from the main circulation pump with the
included T pieces (10). The flow rate is adjusted by the valve (8) and the drop counter (14).
7. Starting
Before starting, the Nitratereductor is filled with aquarium water and controlled for leaking and the right
position of the sealing. Take care for exact positioning of the O-ring. Close the 8 clamps tightly. The internal
circulation pump can be switched on.
Connection to an existing aquarium
If a Nitratereductor is connected to an existing aquarium with a rather high nitrate level, the inflow of aquarium
water should not immediately be started. The bacterial growth is enhanced by the addition of 4 dosing spoons
denimar-powder. If, after 8 - 10 days, the nitrite has disappeared from the reductor - a residual concentration
of nitrate is harmless - the water flow can be switched on.
Connection to a new aquarium
If connected to a new aquarium, the bacteria do not have to be fed within the first 4 weeks, as the nitrate
forming bacteria Nitrosomonas and Nitrobacter need this time to develop and to oxydize the whole amount of
ammonia and nitrite into nitrate.
10
) can escape through
2