General Outline; Maintenance And Demolition - BFT PHOBOS BT Manuel D'utilisation

ENGLISH
Thank you for buying this product, our company is sure that you will be more
than satisfied with the product's performance. The product is supplied with
a "Warnings" leaflet and an "Instruction booklet". These should both be
read carefully as they provide important information about safety, installation,
operation and maintenance. This product complies with the recognised
technical standards and safety regulations. We declare that this product is
in conformity with the following European Directives: 89/336/EEC and 73/
23/EEC (and subsequent amendments).

1) GENERAL OUTLINE

Electromechanical piston designed to automatically operate residential
gates. The irreversible gearmotor keeps the gate locked both in the closing
and opening positions, making the use of the electric lock redundant.
The actuator is supplied with an electronic torque limiter. The unit is
controlled by means of an electronic control board with torque adjustment.
End-of-stroke operation is controlled by two magnetic limiting devices.
The actuator features an obstacle detection system in compliance with
EN12453 and EN 12445 Standards.
The following optional accessories are available on request:
- Buffer battery kit mod. BT BAT
Allows operation of the automation even when there is no mains power
supply for a short period of time.
2) SAFETY
If correctly installed and used, this automation device satisfies the required
safety level standards.
However, it is advisable to observe some practical rules in order to avoid
accidental problems.
• Before using the automation device, carefully read the operation
instructions and keep them for future reference.
• Keep children, people and things outside the automation working area,
particularly during its operation.
• Keep radio control or other control devices out of children's reach, in
order to avoid any unintentional automation activation.
• Do not intentionally oppose the leaf movement.
• Do not modify the automation components.
• In case of malfunction, disconnect the power supply, activate the
emergency release to have access to the automation and request the
assistance of a qualified technician (installer).
• Before proceeding to any outside cleaning operation, disconnect the
power supply.
• Keep the photocell optical components and light signal devices clean.
• Check that the safety devices (photocells) are not obscured by branches
or shrubs.
• For any direct assistance to the automation system, request the help of
a qualified technician (installer).
• Have qualified personnel check the automation system once a year.
3) EMERGENCY MANOEUVRE
All controllers feature a key release mechanism. After lifting the lock cover
(fig.1), insert the release key supplied and turn it clockwise by 90°.
Push the leaf manually to open the gate. To reset the motorised operation,
turn the key in the opposite direction and refit the cover.

4) MAINTENANCE AND DEMOLITION

The maintenance of the system should only be carried out by qualified
personnel regularly.
If the power supply cable is damaged, it must be replaced by the manufacturer
or its technical assistance service, or else by a suitably qualified person, in
order to prevent any risk.
The materials making up the set and its packing must be disposed of
according to the regulations in force.
Batteries must be properly disposed of.
4 -
PHOBOS BT Ver. 03
USER'S MANUAL
WARNINGS
Correct controller operation is only ensured when the data contained
in the present manual are observed. The company is not to be held
responsible for any damage resulting from failure to observe the
installation standards and the instructions contained in the
present manual.
The descriptions and illustrations contained in the present manual
are not binding. The Company reserves the right to make any alterations
deemed appropriate for the technical, manufacturing and commercial
improvement of the product, while leaving the essential product
features unchanged, at any time and without undertaking to update
the present publication.
Fig. 1