ShelterLogic ShelterCoat Instructions De Montage page 7

8. INSTALL TOP CROSS RAIL
A. Connect the first cross rail (#11103) to the front end rib and secure it with a 2 inch. bolt (#00648) as shown
in Fig. 7A. HAND-TIGHTEN this bolt.
B. Connect the middle cross rails (#11102) to the first cross rail. Lay them over the top of the middle ribs and
connect using round head bolt (#11133). Fig. 7B.
C. Connect rail #11101 to complete the top cross rail. Connect to end rib with bolt #00648. Fig. 7A.
Top Cross Rail at End Rib
00648
11136
00690
Fig.7A
9. SQUARE THE FRAME
A. Be sure that frame in its final location, which needs
to be as flat and level as possible.
B. Measure across opposite corners.
These distances must be equal to within 1 inch.
C. Check that the front and rear of the frame
measures 22 feet in width.
10. INSTALL AUGER ANCHORS
A. Anchors must be placed inside shelter at the corner
legs. Insert a ¾-inch pipe or steel rod through the eyelet
of the auger and turn the anchor clockwise until the
eyelet is sticking out of the ground 1 to 2 inches allowing
room to be anchored to the legs.
B. Thread cable provided through the eyelet of the Anchor
as indicated in figure 9. Secure the cable with the
clamps provided.
If the ground is too hard, dig a hole with a shovel or post
hole tool. Optional: Fill with cement.
If you are anchoring in gravel, clay, or asphalt,
ShelterLogic recommends the Easy Hook
®
Anchors. Use one at each leg for a stronger, more
secure installation.
11102
11103
™ Drive
Page 7
11101
22 ft.
Fig.9
Middle Rib
05_GP-AA-XXXXXXA-022XXX11_H0
Top Cross Rail OVER Middle Ribs
11133
Fig.7B
00690
Fig.8
22 ft.
End Rib