ShelterLogic ShelterCoat Instructions De Montage page 4

22'x20'x11' is the base frame dimension. Your model may have more middle ribs than shown in the illustration on
page 3. You will receive one extra rib for every extra 4 ft. of building length that you purchase. The basic frame
assembly will remain the same. The cover will be the correct size for the length of the building.
1. PLOTTING THE FRAME:
Before building your shelter, you should choose a flat area on
your property and plot your shelter.
A. Stake out the area for the shelter in the desired spot. The width of
the area should be at least equal to the width of the shelter and the
length should be equal to the length of the shelter Fig. 1.
B. Measure diagonally from corner to corner (A & B). These
measurements should be the same. If they are not equal the stakes
need to be adjusted until the width, length and inside measurements
are correct.
2. ASSEMBLE TRUSSES
Assemble all of the trusses as shown. Securely
fasten the joints with the hardware indicated.
3. ASSEMBLE END RIBS
Assemble end ribs as shown in Fig. 2. Securely fasten all of the joints with #11131
(2-3/4") Bolts and Nuts.
Fig.2
11068
11013
11016
NOTE: FRAME EXTENSION KIT
11136
11068
800402
11131
11068
00690
Page 4
00682
800402
00690
11068
800403
11068
05_GP-AA-XXXXXXA-022XXX11_H0
22 ft.
WIDTH
A
B
BUILDING
LENGTH
Fig.1
800403
11068
11013
11016