ShelterLogic ShelterCoat Instructions De Montage page 10

13. INSTALLING COVER AND COVER RAILS
A. Make sure cover is centered on frame. There should be an equal amount of overhang at all four corners.
B. Insert the "S"- Hook on ratchet into hole on the leg bend. Insert the webbing into the spindle of the ratchet
and pull tight. Wind the ratchet so that the webbing overlaps itself.
C. Slide cover rails (#11105) through fabric pockets at each leg and reattach with clamps to each leg. Repeat
this on other side. Push down on cover rails to tighten cover, before tightening bolts completely.
D. Check and tighten Ratchets and Cover Rails monthly to ensure the cover is tight.
NOTE: The ShelterLogic
be oriented as shown below.
INCORRECT
Webbing and Ratchets Securing Cover
logo should
®
CORRECT
REAR
End Rib Cross Rail Clamps
11106
11130
11105
11105
00690
Page 10
Fig. 12
COVER RAILS
11105
Middle Rib Cross Rail Clamps
11107
00690
00690
05_GP-AA-XXXXXXA-022XXX11_H0
FRONT
11130
11105