GiBiDi BE24 Mode D'emploi page 19

BE24
10 - DIP SWITCH DIP2
The settings are stored during the rest phase (gate closed).
The default settings are highlighted in the boxes with grey background.
DIP Function
FUNCTIONING
changing this setting will
2_4
reset the control board and
a new learning cycle will be
required.
ANTI
2_5
CRUSHING
SPIA
2_6 /
FLASHING LIGHT
2_7 UNUSED
2_8 UNUSED
UNUSED
2_9
2_10 UNUSED
Status
ON ENCODER
TIME
OFF
Anti crushing active.
-It is not active in the proximity of mechanical end stops.
-After anti crushing intervention the gate will reverse its movement for 1s, after a short
pause the movement will continue at slow speed.
ON
-Subsequently to 3 consecutive anti crushing interventions the control board will
STOP and a user command will be required to start again the motion.
-Anti crushing is not active when working by time ( DIP2_4 = OFF)
Anti crushing disabled.
OFF
Terminal M2_7 and M2_8 work as WARNING LIGHT.
ON
Terminal M2_7 and M2_8 work as FLASHING LIGHT.
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
Description
19
UK