MovingPeople YeS Série Manuel D'utilisation page 59

Troubleshooting table 'Shark'
If the wheelchair will not function, while
the batteries are fully charged, check the
following points before contacting your
dealer.
•
Switch off the wheelchair and then
switch it on again. Check if the
problem has been solved.
•
Check if all charge plugs are properly
connected and secured.
•
Check if the wheelchair is in the D
position (not in N
EUTRAL
•
Check if the position of the speed
control has not changed.
In case of a malfunction the battery
indicator lights will be flashing on the
(Shark controller). On the Shark lights and Shark seats-lights controllers the spanner
symbol will be flashing (X). Use the table below to find out the cause and report this
information to your dealer.
Flashing Fault description
frequency
indicator lights
5 Motor 1 is in the N
6 Motor 2 is in the N
In all other cases contact your dealer.
¨
RIVE
).
position
EUTRAL
position
EUTRAL
Troubleshooting
Action
Put the free wheel lever of
motor 1 in the D position
RIVE
Put the free wheel lever of
motor 2 in the D position
RIVE
59