Troubleshooting Table 'Dx' - MovingPeople YeS Série Manuel D'utilisation

Troubleshooting
6 Troubleshooting

Troubleshooting table 'DX'

Signal Possible cause
ON/OFF light is not on; The plug of the controller
the wheelchair does is not properly placed in
not drive. the 'power module".
The battery charger is still
connected to the
controller.
Neutral is still on.
The batteries are not
properly connected.
A connection of the
batteries is loose.
ON/OFF light flashes 7 The battery is too low.
times
The batteries are empty.
ON/OFF light flashes 8 The battery voltage is too
times high, so that it exceeds 32
V.
ON/OFF light flashes System does not 'fit'.
12 times. System modules are not
compatible.
In all other cases contact your dealer.
58
Remedy
Place the plug properly in the
"power module" (DX BUS).
The DX power module is behind
the cover that is on the outside
under the chair against the battery
tray.
Take the plug of the charge cord
from the charging connection.
•
Switch the wheelchair off
electrically.
•
Switch off neutral.
•
Switch the wheelchair on.
Check the connections.
Secure the connection.
Charge the batteries.
Charge the batteries.
This can only occur at charging.
After checking press the ON/OFF
key back to start driving.
¨