Factory Default Settings - NETGEAR MBR1210 11n Guide D'utilisation

Factory Default Settings

Use the Restore Factory Settings button located on the bottom of your router to reset all
settings to their original factory default settings. This is called a hard reset. To perform a hard
reset, push and hold the Restore Factory Settings button for 6 seconds. Your router will return
to the factory configuration settings that are shown in the following table.
Feature
Router User login URL
login
User name (case-sensitive)
Login password (case-sensitive)
Internet WAN MAC address
Connection
WAN MTU size
Port speed
Local LAN IP
network
Subnet mask
(LAN)
RIP direction
RIP version
RIP authentication
DHCP server
DHCP starting IP address
DHCP ending IP address
DMZ
Time zone
Daylight saving time adjustment
Firewall Inbound communication from the
Internet
Outbound communication to the
Internet)
Source MAC filtering
92 | Appendix A. Supplemental Information
Mobile Broadband 11n Wireless Router MBR1210 User Manual
Default Behavior
http://www.routerlogin.net or http://www.routerlogin.com
admin
password
Use default address
1500
AutoSense
192.168.0.1
255.255.255.0
None
Disabled
None
Enabled
192.168.0.2
192.168.0.254
Disabled
EST for North America
Disabled
Disabled (except traffic on port 80, the HTTP port)
Enabled (all)
Disabled