NETGEAR MBR1210 11n Guide D'utilisation page 78

2.
Select the radio button of the static route you want to configure.
3. Click Add or Edit to display the following screen:
4.
Fill in or change the fields:
• Route Name. The route name is for identification purposes only.
• Private. Select this check box if you want to limit access to the LAN only.
The static route will not be reported in RIP.
• Active. Select this check box to make this route effective.
• Destination IP Address, and IP Subnet Mask. If the destination is a single host, type
a subnet value of 255.255.255.255.
• Gateway IP Address. This must be a router on the same LAN segment as the router.
• Metric. Type a number between 2 and 15. This represents the number of routers
between your network and the destination. Usually, a setting of 2 or 3 works, but if this
is a direct connection, set it to 2.
5. Click Apply to save your changes. If you added a static route, it is added to the Static
Routes screen.
78 | Chapter 5. Advanced
Mobile Broadband 11n Wireless Router MBR1210 User Manual