Use Push 'N' Connect (Wps) To Configure Your Wireless Network; Wps Button - NETGEAR MBR1210 11n Guide D'utilisation

Mobile Broadband 11n Wireless Router MBR1210 User Manual
Use Push 'N' Connect (WPS) to Configure Your Wireless
Network
To use Push 'N' Connect, your wireless computers or devices must support Wi-Fi Protected
Setup (WPS). Compatible equipment usually has the
configure the network name (SSID) and set up WPA/WPA2 wireless security for the router
and the wireless computer or device at the same time.
WPS considerations:
•
NETGEAR's Push 'N' Connect feature is based on the WPS standard. All other
Wi-Fi-certified and WPS-capable products should be compatible with NETGEAR
products that implement Push 'N' Connect.
•
If your wireless network will include a combination of WPS-capable devices and
non-WPS-capable devices, NETGEAR suggests that you set up your wireless network
and security settings manually first, and use WPS only for adding WPS-capable devices.

WPS Button

Any wireless computer or wireless adapter that will connect to the router wirelessly is a client.
The client must support a WPS button, and must have a WPS configuration utility, such as
the NETGEAR Smart Wizard or Atheros Jumpstart.
To use the router WPS button to add a WPS client:
1.
Log in to the router as described in
2.
On the router main menu, select Add
WPS Client, and then click Next.
By default, the Push Button
(recommended) radio button is
selected.
3.
Either click the onscreen button or
press the WPS button on the front of
the router.
The router tries to communicate with the client (the computer that wants to join the
network) for 2 minutes.
4.
Go to the client wireless computer, and run a WPS configuration utility. Follow the utility's
instructions to click a WPS button.
5.
Go back to the router screen to check for a message.
WPS symbol on it. WPS can
Log In to Your Router
Chapter 2. Wireless Network Configuration
on page 12.
WPS
button
| 31