NETGEAR MBR1210 11n Guide D'utilisation page 17

Mobile Broadband 11n Wireless Router MBR1210 User Manual
Table 3. Settings
Fields and Check Boxes
User Name
Password
Country
Internet Service Provider
Access Number
PIN code
APN
PDP type
Connect automatically at startup
Reconnect automatically when
connection is lost
Roaming automatically
Use internal antenna
Wireless Button Configuration
Connection status
Description
Internet account login user name.
Internet account password for authentication.
Select your country from the drop-down list.
Select your Internet Service Provider from the drop-down list.
The remote site's phone number.
Pin code of the SIM card, where applicable.
Access point name.
Select the type of packet data protocol:
• IP
• PDP-IP
• PPP
• PPP-IP
When this check box is selected, the modem automatically connects
to the network when powered up. This should be selected after login
information is provided.
When this check box is selected, the modem will attempt to
reconnect to the network when the connection is lost. Under normal
situations, this setting should be selected.
When this check box is checked, the unit might roam to any available
operator in range and might incur roaming charges.
If this check box is selected, the router will use the internal antenna
rather than the external antenna.
Select the option to determine the behavior of the WPS push button
on the front panel when pressed.
• Control Wi-Fi Only : Pressing the push button toggles the Wi-Fi
function. If Wi-Fi is turned on, pressing the push button turns off the
Wi-Fi. Pressing it again will turn on the Wi-Fi. This function is
available only if the Wi-Fi function is enabled. The Wireless
Broadband function is unaffected.
• Control Both Wi-Fi and Wireless Broadband: Pressing the push
button toggles both the Wi-Fi function and wireless broadband at
the same time. If Wi-Fi is turned on, pressing the push button turns
off the Wi-Fi. At the same time, the wireless broadband connection
is disconnected. If you press the push button again, Wi-Fi is turned
on and the router attempts to re-establish the wireless broadband
connection. Depending on the coverage, wireless broadband
coverage might or might not be connected successfully.
Current WAN port status.
Chapter 1. Connecting to the Internet | 17