Panasonic AW-HE50HE Mode D'emploi page 75

Web setting screen
Notes
w p After the Execute button has been pressed, it
will take about one minute with the Camera Main
software or about 3 minutes with the Network
software for the progress bar that indicates the
progress made in the version upgrading to appear.
w p Use the personal computer on the same subnet as
the camera to upgrade the software version.
w p Before using the version upgrading software, be
absolutely sure to check the precautions to be
observed with your dealer, and follow the dealer's
instructions.
w p Use the following files specified by Panasonic
Corporation as the software used for version
upgrading.
Camera Main bin files
Network img files
w p Be absolutely sure to write the filenames as below
(see *) for the files of the software used for version
upgrading.
Camera Main he50_cameramain_xxxxx.bin*
Network he50_network_xxxxx.img*
*: Enter the software version in the "xxxxx" part.
w p Do not turn off the unit's power while a software
version is being upgraded.
(Do not turn off the power until the progress bar
display is cleared.)
w p While a software version is being upgraded, do not
attempt to execute any other operations until the
version has been upgraded.
w p Even when "Reset the settings to the defaults
after completing the upgrade" has been selected,
the network‑related data listed below will not be
initialized.
· DHCP On/Off
· IP address
· Subnet mask
· Default gateway
· HTTP port
· Line speed
· Bandwidth control (bit rate)
74 (E)