Priority; Periodic Message; Outputs Page; Output Settings - Bentel Security BGSM-G/AM Mode D'emploi

Priority

This section will allow you to select the operating priority of this Device: Interface (at default) or SMS Dialer/Contact ID Commu-
nicator.

Periodic message

This section will allow you to set up the Periodic message options.
† Date of first Periodic message - Select the Date of the first Periodic message.
† Time of the first Periodic message - Select the Time of the first Periodic message.
† Interval - Enter the interval (DD-HH-MM) between each Periodic message. Accepted DAY values: 0 to 693.
, , , , , ATTENTION: If Input Line 2 is assigned to Special functions (Column A), transmission of the Periodic message will
be subordinate to 'Unbalance' on Input Line 2 (refer to the 'Special functions' table). If this occurs, the Date and
Hour of the Periodic message will be irrelevant.
To send the SMS it is necessary enter a Customer Code (e.g. 1111) for the relevant event (see the column 'Customer
Code' in the Contact ID Page).
If the external power supply (connected to terminals [+12V]) and battery power supply drop at the same time, the Device
must be re-programmed after the power supply is restored, otherwise the time set for the Periodic Message could NOT be
respected.

Outputs Page

This page will allow you to set up and control the outputs.

Output Settings

† Polarity: select the polarity of the output: H-Normally Open L-Normally Closed.
† For Land Line Trouble, GSM Trouble, etc.: select the events that will activate the outputs.
† Reserved Output: If this option is selected, all other events assigned to the output in this section will be ignored. Select this option, if
the output concerned is to be used for Remote control purposes (refer to "Activating and Deactivating and Remote Control Outputs").
The following options will affect Reserved Outputs ONLY.
† Output Label - Type in the label (max. 8 characters) of the appliance (e.g. Gate) which is to be remote-controlled via SMS.
† Output feedback - Select the type of feedback signal (None, Ring or SMS) to be sent when the respective output activates.
If the Output Label field is empty, the SMS option will not be available.
† Monostab. - Under normal circumstances, these outputs hold active status until they receive a deactivation command. If
automatic deactivation is required, it will be necessary to program the ON Time (i.e. the time the output will hold active status).
† ON Time (sec.) - Enter the required ON Time in seconds (accepted values 2 to 254 seconds). If the output has been
programmed as Monostable, this value will determine the amount of time the output will hold active status before restoring to
standby.

Access Code

Type in the code (maximum 4 alphanumeric characters) which will allow the user to control the outputs over-the-phone.
26
GSM/GPRS Alarm Communnicator