Lincoln Electric LINC FEED 37 Manuel D'utilisation page 13

E. Memory Function - Recalling Memory (LF 38 Only)
Description:
The saved Memory configurations can be recalled.
Set-Up:
While pressing the Prog button, rotate the left knob until "RECALL MEMORY"
appears on the display.
Selection:
Release the Prog button, then rotate the left knob to scroll through the saved
memory configurations. Only the memory locations that have been used will be
available. Once selected, begin welding.
Welding:
While welding in Memory Mode, the Non-Synergic Voltage or the Synergic
Trim values can be varied approximately 5% using the right knob. This allows for
fine adjustment of the welding characteristics.
To Exit:
To return to Non-Synergic or Synergic welding, press the Prog button and rotate
the left knob until the proper parameter appears. See sections A and B for further
details.
Memory Screen Example:
A-8