Description - Hilti TE 1000-AVR Mode D'emploi

Obligation signs
en Wear eye Wear a hard
protection
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Volts Amps
Double Lock symbol
insulated

2 Description

2.1 Use of the product as directed
The power tool is an electrically-powered breaker with electropneumatic hammering mechanism designed for heavy
chiseling work.
The power tool is designed for breaking / removing and demolishing concrete, masonry, stone or asphalt.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Nationally applicable industrial safety regulations must be observed.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be used only in a dry environment.
Do not use the power tool where there is a risk of fire or explosion.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
2
Wear ear
hat protection
Chiseling
Alternating
current
Equipped
with theft
protection
system
Location of identification data on the power tool
The type designation can be found on the type identifica-
tion plate and the serial number on the side of the casing.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Wear
protective
Type:
gloves
Serial no.:
Chisel
position
adjustment
Hertz