Description - Hilti TE 2-A22 Mode D'emploi

Obligation signs
Wear eye Wear a hard
protection
en
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Volts Direct
current
Diameter Forward /
reverse

2 Description

2.1 Use of the product as directed
The tool is a hand-held, battery-powered rotary hammer for hammer drilling in concrete and masonry, for drilling in
steel, wood and masonry and for driving in and removing screws.
Use only the batteries and chargers recommended by Hilti.
The power tool may be used only in a dry environment.
Do not use the power tool where there is a risk of fire or explosion.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
Modification of the power tool or tampering with its parts is not permissible.
Do not use the battery as a power source for other unspecified appliances.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
16
Wear ear
hat protection
Drilling
without
hammering
Rated speed
under no
load
Location of identification data on the power tool
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Wear
protective
Type:
gloves
Generation: 02
Serial no.:
Hammer
drilling
Revolutions
per minute