Hitachi Koki NV 50AH Mode D'emploi page 5

Adjust the position of the nail holder according to the
length of the nail. (Fig. 2)
Magazine
Fig. 2
For adjustment, turn
counterclockwise about 90 degrees. Move the nail
holder 2 up and down, adjust to the length of a nail
to be used, and adjust the surface of the nail holder to
the marked position of the magazine.
Turn the nail holder 3 clockwise (about 90 degrees)
until it goes click. (Fig. 3)
Magazine
For 27 mm
For 32, 38 mm
For 45, 50 mm
Fig. 3
Load the nails in the magazine.
At this time, if the wound portion of nails is inserted
after it is once pulled out beforehand, the subsequent
work can be much facilitated. (Fig. 4)
Magazine
Nail Holder
Opening
First Nail
Fig. 4
Bring the nail holder down to the magazine side,
and close the cover after making sure that the nails
are completely loaded in the magazine.
Cover
Nail Holder
the nail holder
Nail Holder
Magazine
Cover
Nail
NOTE:
Before loading the nails in the magazine, position the
nail holder according to the length of the nail. If the nail
holder position is not adjusted, the nail jams. If the
cover is forcibly closed without adjusting the position
of the nail holder, the nail holder may be damaged.
(2) Load nails in the guide
Extend the nail line from the magazine.
Insert the first nail into the driving hole and the
second nail between the pawls of the feeder. Insert
the nail so that the nail head engages the guide slot.
(Fig. 5)
First Nail
1
Nail Guide
Feeder
Nail outlet
(3) Close nail guide
After making sure that the cover is closed, hook your
finger to the nail guide and the knob, and while
pushing the knob down, turn the nail guide clockwise
to completely close it. (Fig. 6)
The above operation completes the loading of nails.
Knob
Nail Guide
NOTE:
The nail guide may not close properly or the nails may
not advance properly if the linked bands or nails do
not enter into the indicated position or the nails come
away from the guide surface or the wire linked nails
are warped.
CAUTION:
To prevent unintentional operation, never touch the
trigger or place the top end of the push lever on a work
bench or floor. Also, never face the nail outlet toward
any of a person.
English
Guide Slot
Feeder
Guide Surface
Fig. 5
Cover
Fig. 6
4