Hard Wiring Installation - Napoleon Allure Serie Manuel D'installation Et D'utilisation

installation
EN
3.5

hard wiring installation

! WARNING
• Turn off the appliance completely and let cool before servicing. Only a qualifi ed service person should service
and repair this electric appliance.
HARD WIRING CONNECTION
If it is necessary to hard wire this appliance, a qualifi ed electrician must remove the cord connection, and wire the
appliance directly to the house hold wiring. The wire and power supply breaker must be rated for 120V minimum
15 amps.
This appliance must be electrically connected and grounded in accordance with local codes, if hard wired. In the
absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the current
ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.
A. Remove the cover plate from the botTom right
side of the appliance by removing the
3 screws (Fig. 1).
C. Punch out the 7/8" (22.2mm) hole in the new cover plate (supplied) (Fig. 2) and install a box connector
into the junction box. Snap the box connector clamp onto the supply wires.
D. Using the wire connectors, connect the ground green wires (G) and the common white wires (N)
together, and then connect the hot black wires (L) (Fig. 3 and 4).
E. Reinstall the cover plate using 3 screws (Fig. 1).
G
16
W415-1542 / G / 02.07.20
COVER PLATE
Fig. 1
N
L
Fig. 3
7/8" (22.2mm)
Diameter
B. Remove the wire connectors from the
power cord. The power cord may be
discarded.
Fig. 2
Fig. 4