Maintenance; Remote Battery Installation - Napoleon Allure Serie Manuel D'installation Et D'utilisation

6.0 maintenance

EN
!
WARNING
• In preparation for maintenance, always disconnect the power and allow the electric appliance to cool before
performing any cleaning, maintenance or relocation of this electric appliance. Turn controls to off and remove
plug from outlet or turn off the house circuit breaker to electric appliance receptable.
• Do not install replacement lamps that exceed specifi ed maximum watts.
• The halogen lamps in your appliance can become extremely hot. Allow at least 10 minutes between turning
off the appliance and removing the lamps to avoid accidental burns.
• Do not handle the lamp with bare fi ngers. Oils from your skin will damage the lamps when they heat up. Use
gloves or a clean dry cloth when handling lamps.
6.1

remote battery installation

note:
The remote control has a removable plastic tab to prolong the battery life while shipping, remove the tab for the
remote control to function.
1. To replace the existing battery remove the battery
holder.
2. To remove the battery holder turn remote onto rear
side and press the left side lever towards the center
while pulling the battery holder out using the slot
provided.
3. Replace existing battery, type CR 2025, with a new
battery and reinstall the battery holder into the remote
by sliding it into position.
note:
The remote control must remain within 5 meters or 17 feet of the appliance to be effective. This range may be
reduced when battery power is depleted.
20
W415-1542 / G / 02.07.20
BATTERY (CR 2025)
BATTERY HOLDER
REMOTE
(REAR SIDE)