Hard-Wiring Installation; Junction Box - Napoleon Allure Vertical Serie Manuel D'installation

4.2

hard-wiring installation

WARNING
!
• Turn off the appliance completely and let cool before servicing. Only a qualified service person should service
and repair this electric appliance.
HARD WIRING CONNECTION
If it is necessary to hard wire this appliance, a qualified electrician must remove the cord connection, and wire the
appliance directly to the household wiring. The wire and power supply breaker must rated for 120V minimum 15
Amps.
This appliance must be electrically connected and grounded in accordance with local codes, if hard wired. In the
absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the current
ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.
note:
There are 3 wires from the appliance junction: white (neutral), black (power L1), and green (ground) that
connect to 120V power supply (breaker panel). See below.
WHITE
BLACK
GREEN

Junction Box

Remove the 4 securing screws from the electrical cover plate, located on the bottom left hand side of
A.
the appliance (when viewed from the rear).
Install the strain relief to the electrical cover plate (located in hardwire bag).
B.
Separate the black, white and green wires that have the wire nuts on them.
C.
Remove the wire nuts and secure the black wire (power L1) to the black (power L1) lead of the power
D.
supply. Connect the white wire from the appliance to the white (neutral) wire from the power supply.
Connect the green wire to the ground wire.
Resecure the electrical cover plate.
E.
Rear View
of Appliance
F
J
I
U
R (L1)
BLACK
N
E
C
P
WHITE (N)
T
L
I
A
GREEN (G)
O
C
N
WIRE NUT
E
electrical information
WHITE
BLACK
GREEN
Junction Box
C
E
H
M (L1)
NEGRO
I
P
M
A
BLANCO (N)
E
L
N
M
VERDE (G)
E
E
A
TUERCA DEL
CABLE
BLACK
WHITE
GREEN
White, Green and
Black wires:
Connect to 120V
power supply.
NEGRO
BLANCO
VERDE
S
P
U
O
P
W
P
E
L
R
Y
W415-1830 / G / 07.20.20
EN
S
U
P
M
O
T I
D N
E
E I
N
C S
T
I
R
A
O
19