general information
EN
1.4
listing approvals
This appliance has been tested in accordance with the CSA Standards for fi xed and location-dedicated electric
room appliances in the United States and Canada. If you need assistance during installation, please contact your
local dealer.
note:
This appliance must be electrically wired and grounded in accordance with local codes or, in the absence of
local codes, with National Electric Code ANSI/NFPA 70-latest edition in the United States or the Canadian
Electric Code, CSA C22.1 in Canada.
1.3
general instructions
•
Prior to plugging your appliance into an electrical outlet, verify that the house circuit breakers for the outlet
are on.
•
The appliance may emit a slight, harmless odour when fi rst used. This odour is normal and it is caused by
the initial heating of internal appliance elements and will not occur again.
•
If your appliance does not emit heat when called for, consult the "operation" section of this manual for further
information.
•
Use with a CSA or UL certifi ed surge protector.
•
Do not route the power cord directly underneath the appliance.
This electric appliance meets the construction and safety standards of H.U.D. for application in manufactured
homes when installed according to these instructions.
As with most electronic devices, your new electric appliance has been designed to operate at
temperatures between 5°C (41°F) and 35° C (95°F). During the colder winter months, allow the appliance
to reach room temperature before turning it on.
1.5
unpacking and testing appliance
Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the appliance
operates properly by plugging the power supply cord into a conveniently located 120 Volt, 15 Amp grounded
outlet.
note:
NEFL72/100FH appliances are shipped with the front glass not assembled onto the appliance. See "front glass
installation" section for assembly.
6
W415-1542 / G / 02.07.20