Proxxon LWB/E Mode D'emploi page 14

The wheel may bind, walk up or kickback
if the power tool is restarted in the work-
piece.
g) Support panels or any oversized work-
piece to minimize the risk of wheel
pinching and kickback. Large work-
pieces tend to sag under their own weight.
Supports must be placed under the work-
piece near the line of cut and near the
edge of the workpiece on both sides of the
wheel.
h) Use extra caution when making a
"pocket cut" into existing walls or
other blind areas. The protruding wheel
may cut gas or water pipes, electrical
wiring or objects that can cause kickback.
Safety warnings specific for wire brushing
operations:
a) Be aware that wire bristles are thrown
by the brush even during ordinary op-
eration. Do not overstress the wires by
applying excessive load to the brush.
The wire bristles can easily penetrate light
clothing and/or skin.
b) Allow brushes to run at operating
speed for at least one minute before
using them. During this time no one is
to stand in front or in line with the
brush. Loose bristles or wires will be dis-
charged during the run-in time.
c) Direct the discharge of the spinning
wire brush away from you. Small parti-
cles and tiny wire fragments may be dis-
charged at high velocity during the use of
these brushes and may become imbed-
ded in your skin.
For use in dry environments only
Protection class II device
Wear safety glasses!
- 14 -
Please do not dispose off
the machine!
Description of the machine
Because of its construction, the LWB/E angle
drill can be operated even at inaccessible
areas that cannot be reached with conven-
tional drills. This is made possible through the
long slender neck of the aluminium die-cast
head and the mitre gear, which enables the
drill to be aligned by 90°. With the compre-
hensive range of commercially available ac-
cessories, other work is also possible such as
drilling, grinding, milling and polishing and
more. The LWB/E is powered by a quiet direct
current motor for a long service life and great-
est reliability. The supplied collets can clamp
the shafts of the bits and cutters up to max.
3.2 mm, guaranteeing greatest concentric ac-
curacy.
General view (Fig. 1)
1. Adjustable speed dial
2. ON/OFF switch
3. Bow
4. Connecting cable
5. Locking button
6. Steel collet chucks
7. Union nut for collet chucks
Scope of delivery
1 pc. LWB/E long-neck angle drill
1 pc. Storage case
1 pc. Operating instructions
1 pc. Safety guidelines
1 pc. Steel collets
(1 each for 1.0 – 1.5 – 2.0 – 2.4, 3.0 and
3.2 mm)
Technical data
Motor:
Voltage: 230 V/50 – 60 Hz