Normal Maintenance - Eccotemp iE Série Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483
TROUBLE-SHOOTING
Problems
1. Inlet and outlet fittings leaking
2. No LED signal
3. Functional keys not working
4. Water too hot
5. Water too cold
6. Reduced outlet water pressure
7. LED displays E1
8. LED displays E3
9. Display overload
7 and 8 should only be performed by qualified electrician. The person who initially installed the unit is the best one to contact for
help.

NORMAL MAINTENANCE

Note: Do not attempt to repair this water heater yourself. Call a service person for assistance. Always turn off all power
supply to the unit. Turn off all circuit breakers supplying power to the appliance *please note some units are connected
multiple circuit breakers. Turn OFF ALL WATER SUPPLY and ALL POWER SUPPLY.
This unit does not require any regular maintenance. However, to ensure consistent water flow, it is recommended to follow
the following procedures.
1. Periodically remove scale and dirt that may build up at the aerator of the faucet or in the shower head.
2. There is a built in filter screen at inlet connection which should be cleaned from time to time. Please turn off the water flow
before doing this.
EXPLOSIVE VIEW
PLEASE NOTE: THIS MANUAL IS SUBJECT TO CHANGE AT ANYTIME, TO ENSURE THIS MANUAL IS UP TO DATE PLEASE VISIT OUR HELP DESK
12
Product Support: Eccotemp.com/help-desk
Possible Causes
A. Fittings are not tight
B. Rubber washer worn-out
A. Power not connected.
B. LED damaged.
A. No water out from shower.
B. Water pressure too low.
C. Key or PCB damaged.
A. Too high temperature set.
B. Water flow too little.
A. Low temperature set.
B. Water flow too much.
Inlet strainer or shower clogged.
Outlet temperature is over 67°F/153°F
Temperature sensor failure
Inlet water flow is too high.
AT WWW.ECCOTEMP.COM FOR ALL OF OUR PRODUCT MANUALS.
Shop Online: Eccotemp.com/products
Corrective Actions
A. Tighten fittings.
B. Change rubber washer.
A. Connect power to the unit.
B. Change LED.
A. Open valve to get water.
B. Open valve to get pressure.
C. Change key or PCB.
A. Set a lower temperature.
B. Open valve more.
A. Set a higher temperature.
B. Reduce water flow.
Clean strainer and shower.
A, Reduce the temperature
B, Turn up the water flow
Please contact with your local dealer
Reduce the inlet water flow
Store Locater: Eccotemp.com/locater

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ie-11Ie-15aIe-15bIe-18Ie-24Ie-27

Table des Matières