Eccotemp iE Série Manuel D'utilisation Et D'entretien page 11

Phone: 866-356-1992 | Email: Support@eccotemp.com | Address: 315 - A Industrial RD Summerville, SC 29483
INSTALLATION LOCATION & METHOD
Fixed installation on the wall
Locate an appropriate place on a section of wall that meets all safety and installation requirements
Fig 1
Front and back of the appliance
Fig 2
Remove screw which fixed the bracket on back of the appliance.
Fig 3
Hold the back bracket hanger in position against the wall in the desired hanging location. Check to
make sure that the bracket is level. Mark the wall where the mounting holes should be located. Drill holes of 1/4"
diameter in the marked locations. If you are on a stud, screw the bracket directly into the wall. If you are not on a
stud, insert the plastic anchor in the hole, and secure the bracket using the screwing supplied.
1.2 in.
1.2 in.
PLEASE NOTE: THIS MANUAL IS SUBJECT TO CHANGE AT ANYTIME, TO ENSURE THIS MANUAL IS UP TO DATE PLEASE VISIT OUR HELP DESK
Product Support: Eccotemp.com/help-desk
2.5 in.
2.5 in.
AT WWW.ECCOTEMP.COM FOR ALL OF OUR PRODUCT MANUALS.
Shop Online: Eccotemp.com/products Store Locater: Eccotemp.com/locater
7