Attachment Of Electrode Lead Wires; Start; Program,Speed,Time - Gima 28365 Manuel De L'utilisateur

31

2. Attachment of electrode lead wires

a. The wires provided with the AD-2040 insert into the jack sockets located
on top of the device. Holding the insulated portion of the connector, push
the plug end of the wire into one of the jacks; one or two sets of wires
may be used.
b. After connecting the wires to the stimulator, attach each wire to an
electrode.
Use care when you plug and unplug the wires. Jerking the wire instead
z
of holding the insulated connector body may cause wire breakage.
c. Place the electrode on your body as directed by your physician.
Clean the wires by wiping with a damp cloth.
z
Σ
IVD
1
Wires stay away from babies and children, prevent the winding neck
causing suffocation and death.
Σ
IVD
1
PHTHALATES

3. Start

PHTHALATES
Press the
See picture 1.
Note: the backlight will be turn off automatically in 20 seconds after your last
operation. And then press any button the backlight will be light again.)
4. Program, speed, time
Press the
1 ProGrAM
See picture 2, when program display on the LCD, press + or – button,
you can chose the different program, total 30 programs.
2 SPEED
See picture 3, when speed display on the LCD, press + or – button,
you can chose the different speed, from 1-9total 9 degrees.
3 tiME
See picture 4, when time display on the LCD, press + or – button,
you can chose the different time, from 1-99 total 99 minutes.
button, and backlight is light. LCD value initiated.
button to chose the PROGRAM, SPEED , TIME function.
ENGLISH