Paoli DP 36 SF EVO Manuel D'utilisation Et D'entretien page 4

TECHNICAL DATA
DESCRIPTION
Portable air impact wrench designed for
motorsport application (Best Practice: Touring).
LUBRICANT
Hammer mechanism
grease for Paoli air impact wrench hammer
mechanism.
Air motor lubrication: Very fluid oil for air
tools or Special oil for Paoli air impact wrench
motors.
ENVIRONMENTAL CONDITIONS
Temperature: -5 ° C ÷ + 45 ° C
Storage temperature: 0 ° C ÷ + 40 ° C
Air humidity: <80%
Max Altitude: 2000m from sea level
AIR SUPPLY SYSTEM DIAGRAM
View figure Fig.3.
L It is allowed to use exclusively on industrial
plants with compressed air.
L Make use of a supply system that observes the
indicated pressure values (max 10% over the
maximum value indicated) using an air pressure
regulator supplied by a system observing the
current safety standard, and that it is subjected
to regular checks.
L The components of the supply system must be
designed and constructed in accordance with
the safety requirements contained in current
international standards.
Clutch Cover
Motor Cover
* These performances have been obtained after having tested the wheel gun on a testing-bench, that is on fixed bolts,
which have been tightened for 5 seconds. Please remind that, during the tightening on a F.3 or F.NISSAN race car's wheel
hub you lose most of the torque, due to the hub's spin. Furthermore the performances change depending on the utilization-
time of the wheel gun on each nut, reminding that the correct tightening-time on one single nut is, on average, one second.
** US version: Air inlet is ¼" NPT; Maximum free speed is 15.000 RPM (at 14 bar); Ultimate torque is 900 Nm.
ENGLISH
4
OPERATING AND MAINTENANCE MANUAL
lubrication: Special
TAB. A
INTENDED USE
Assembly air tool for threaded fasteners in the
pit stop service.
Weight (kg)
Length (mm)
Square drive
Air inlet
Supply hose inside diameter
Maximum free speed (RPM)
Max weight recommended
power socket (kg)
Operating air pressure (bar)
Ultimate torque* (Nm)
L Before any work on the supply system, always
check that the line is depressurized (no air
pressure).
L It is recommended to use a whip hose (flexible
hose for compressed air with a minimum length
of 46 cm (18 inch)) with a threaded male to
connected to the air inlet of the wheel gun, and a
male quick disconnect coupling at the other end.
L Fit a the whip hose to the air pressure regulator
using a specific supply hose.
L Use a supply pipe of minimum inner diameter
10 mm (3/8") suitable for its intended use.
TIGHTENING TORQUES
M5 Screw
M5 Screw
2,23
161
1/2"
3/8" BSP**
3/8" (10 mm)
14.500** (at 14 bar)
0,60
14 (maximum)
850**
10 Nm
10 Nm