Maintenance And Cleaning - AneX e/type Manuel D'entretien

Seat unit's security barrier
The seat unit is equipped with a barrier,
which prevents your child from falling off
the stroller. To install the barrier, insert it into
the holder bores on both sides of the seat unit
(Fig. 31). To dismantle the barrier, press the
buttons and slightly draw the handle up
(Fig. 31). You can also dismantle one side
of the barrier and leave the other.
Safety belts
The seat unit features 5-point safety belts.
To secure a child with protective belts, insert
the safety belt locks into the grabber and
tighten those belts (Fig. 32). You can also
adjust the length of the safety belts. If you
need to unfasten them, press the buttons
and remove the clips from the buckle (Fig. 32).
Child safety seat
The child safety seat can be mounted on this
stroller's frame as well. It must be attached
to tailor-made adapters (Fig. 33). To secure the
removable child safety seat, insert the adapters
into the adapter pockets on the frame (Fig.
33), then secure it (Fig. 33). The adapters are
blocked automatically. To remove the adaptor
from the frame, press the memory buttons of
the adaptors (Fig. 34). To take the safety seat
off the adaptors, simultaneously push the
buttons under the textile on both sides
of the seat (Fig. 35). It is also possible to adjust
the transportation handle by simultaneously
pressing the red buttons on both sides of the
seat and adjusting to the required position.
The safety seat can be installed both with the
standard car safety belts and with the help
of ISOFIX fixation system.
Please carefully read the manual prior to
using the safety seat.
Installing additional
accessories on the frame
There are special holders situated on both sides
of the frame for TM Anex branded cupholder.
The stroller is also equipped with a shopping
basket, which can be installed at the bottom
of the frame with zippers and buttons (Fig. 36).
A backpack for parents is also provided.

Maintenance and cleaning

Please ensure that the stroller is kept clean
and dry (both the coating and the frame).
In case the stroller gets dirty or wet, it should
be dried, and the metallic parts be cleaned with
a dry cloth. Avoid getting dirt (sand, dust, etc.)
on the stroller. Clean the dirt off the stroller as
soon as possible. Please note that if you do not
do so, the product can stop functioning either
partially or fully.
The cleaning of the stroller's coating can be done
with a wet washcloth or brush and detergent.
There is no need to take the coating off.
The color of materials and textile can fade
when exposed to sunlight for a long time.
The wear level of wheels should be controlled;
the wheels should be cleaned from dirt.
The pressure in the inflatable wheels should be
kept at 0.8 bar.
Besides that, there are eight ball bearings
in the stroller (2 in each wheel), which should
be greased regularly and protected from dirt
and liquids. In the event that such substances
get in, the ball bearings should be cleaned, dried
and greased with several oil drops. Any spillage
of the oil should be wiped with a dry cloth.
EN
9