AneX e/type Manuel D'entretien page 7

PRE-USE PROCEDURES
Stroller assembling/disassembling
Unbox this stroller's frame and put it
horizontally on the floor (Fig. 1). Disable the
lock against accidental unfolding (Fig. 2). Pull
upwards vigorously till the system is secured,
while holding the handle (you should hear a
specific sound) (Fig. 3, 4). Press the button
on the right lever arm of the frame to fold the
frame. After that, simultaneously pull the lever
arms on both sides of the frame all the way
in (Fig. 5). Next, slightly push the frame down
to restore it to the initial position it had at
the moment of unfolding the stroller (Fig. 1).
For easy and efficient use, through the same
sequence of operations, the frame can be
folded together with the seat without taking
the seat unit off the frame. This is upon the
condition that the seat is facing in the direction
of travel, the footrest is in the lowest position,
the hood is folded, and the stroller's handle is
turned down (Fig. 6).
Handle height adjustment
Simultaneously press the round buttons,
placed in parallel on both sides of the handle.
Set a comfortable handle height for you (Fig. 7).
Installation and removal
of rear wheels
Before installing a wheel, insert the axis into
the respective spot at the bottom of the frame
(until you hear a distinctive sound) (Fig. 8). The
wheel should be installed on the axis, then pull
it off slightly until you hear a distinctive click
(Fig. 9). The wheel can be removed both with
and without the axis. Press the button at the
bottom of the frame to remove the wheel with
the axis (Fig. 10). To remove the wheel without
the axis, push the middle part of the wheel
and drag it along the axis until it comes off
completely.
Installation/removal
of the front swivel wheels/lock
The frame of the stroller is equipped with
two front swivel wheels that rotate at 360°.
To fit the front wheels, the wheel axle must
be installed in the appropriate position on the
frame and pushed up until the system is fixed
(Fig. 11). In order to remove the wheel, press
the button. The wheel is automatically
disconnected (Fig. 12). If you need to fix the
swivel wheel system, press the button above
the wheel (Fig. 13). Additionally, for convenience
and efficiency, you can lock the wheels by
pressing the button by both hand and foot.
Brake
The stroller is equipped with a parking brake
that fixes the rear wheels (Fig. 14). To stop the
stroller, press the pedal that blocks the rear
wheels (Fig. 14). To continue driving, turn the
pedal to its original position (Fig. 14).
Shock absorption
The stroller has a spring type shock absorption
system and shock absorption on the frame to
improve your baby's comfort.
Carrycot
To mount the carrycot, place the adapters into
the adapter pockets, located on the frame's inner
side (Fig. 15). The carrycot adapters are blocked
automatically. To take the carrycot off, press the
memory adaptor buttons and lift it up (Fig. 15).
EN
7