Maintenance And Cleaning - AneX AIR-X Manuel D'entretien

check the plastic holder that is on the outside of the
back inside the sewing, pull out the belt together
with the plastic holder, insert the belt with the plastic
holder in the required position, and then make sure
the plastic holder is in correct position (fig 21, 21a).
You can also adjust the length of the safety belts, if
you want to make them shorter - pull the end of the
strap. To extend safety belts - turn the plastic adjuster
up and pull the lower strap. If you need to unfasten
them, press the buttons and remove the clips from
the buckle (fig. 20).
INSTALLING ADDITIONAL
ACCESSORIES ON THE FRAME
The frame is equipped with special fastening
systems for the branded cup holder TM Anex.
Additionally, the stroller features a shopping bag.

MAINTENANCE AND CLEANING

Please ensure that the stroller is kept clean and
dry (both the coating and the frame). In case the
stroller gets dirty or wet, it should be dried, and
the metallic parts be cleaned with a dry cloth.
Avoid getting dirt (sand, dust, etc.) on the stroller.
Clean the dirt off the stroller as soon as possible.
Please note that if you do not do so, the product
can stop functioning either partially or fully.
The cleaning of the stroller's coating can be done
with a wet washcloth or brush and detergent.
There is no need to take the coating off. The color
of materials and textile can fade when exposed
to sunlight for a long time. The wear level of