Adjusting The Feed Speed For The Autonomous Cutting Version (Fig. 10); Correct Positioning Of The Workpiece In The Clamp; Installation And Adjustment Of The Bar Holder (Fig. 5) (Optional) - Femi 780XL Instructions D'installation Et D'entretien

3.5. ADJUSTING THE FEED SPEED FOR THE AUTONOMOUS CUTTING VERSION
(Fig. 10)
a. Lift the arm to its maximum height.
b. Press the catch (17) to release the selector switch (19).
c. Position the selector on the required feed speed (H, M, L, LL).
d. Release the catch.
3.6.

CORRECT POSITIONING OF THE WORKPIECE IN THE CLAMP

Position the workpiece to be cut directly between the jaws, without placing any other object/s
between the workpiece and the jaws.
DANGER - WARNING
TO POSITION FLAT OR SPECIAL SHAPED PROFILES, PLEASE REFER TO THE
EXAMPLES PROVIDED IN THE FIGURE.
IF THE THICKNESS OF THE PROFILE IS VERY THIN, TO STOP IT FROM GETTING
CRUSHED IN THE JAWS OF THE CLAMP, PUSH A MOULD INTO THE PROFILE
WHICH MATCHES ITS SHAPE.
3.7.

INSTALLATION AND ADJUSTMENT OF THE BAR HOLDER (Fig. 5) (OPTIONAL)

a. Install the guide rod (21) in the hole on the base (13).
b. Tighten the nuts (22).
c. Slacken the handwheel (20) and position the bar holder (10) at the required distance.
d. Tighten the handwheel (20).
EN
31