Specific characteristics of the electrical system
DANGER - WARNING
- THE BANDSAW'S ELECTRICAL SYSTEM IS FITTED WITH AN UNDER-VOLTAGE
RELAY WHICH AUTOMATICALLY OPENS THE CIRCUIT IF THE VOLTAGE DROPS
BELOW A MINIMUM SET LIMIT AND INHIBITS AUTOMATIC RESET OF OPERATING
CONDITIONS WHEN THE VOLTAGE RETURNS TO THE SET RATED LEVELS.
- SHOULD THE MACHINE SUDDENLY CUT OUT THERE IS NO CAUSE FOR ALARM.
CHECK THAT THERE HAS NOT BEEN A VOLTAGE FAILURE IN THE MAINS
SUPPLY.
3. ADJUSTMENTS
DANGER - WARNING
- PLACE THE MACHINE IN SAFETY CONDITIONS AS DESCRIBED IN THE HEADING
"GENERAL SAFETY REGULATIONS".
- WEAR PROTECTIVE GLOVES.
- ALL THE PROCEDURES FOR MACHINE ADJUSTMENTS AND USE DESCRIBED
IN THE FOLLOWING HEADINGS MUST BE PERFORMED ONLY AFTER THIS
INSTRUCTION, USE AND MAINTENANCE MANUAL HAS BEEN READ AND
UNDERSTOOD IN FULL.
DANGER - CAUTION
- At the end of every adjustment operation, check that all fasteners are securely
tightened.
- At the end of every adjustment operation make sure no tools have been left on
the machine.
3.1.
ADJUSTING BLADE TENSION (Fig. 4)
Turn the handwheel (2) clockwise up to the travel stop.
DANGER - WARNING
- IF THE BAND TENSION IS TOO HIGH IT MAY JUMP OUT OF THE GUIDES.
3.2.
CUTTING ANGLE - HEAD ROTATION ADJUSTMENT (Fig. 1-6)
NOTES
The machine is supplied with basic calibration set at 0° and 45°, with mechanical stoppers
(23 - 25).
DANGER - WARNING
TO CHECK OR MODIFY CALIBRATIONS, PLEASE CONTACT AN AUTHORIZED
AFTER SALES SERVICE CENTRE.
EN
Cont....
29