Rbm84 Connection Rem (Two Segments) - CAME RBM84 - HW Manuel D'utilisation

RBM84 connection <----> REM (two segments)
NOT INCLUDED
Cable
recommended type:
unshielded
multipair cable
(CAT 5 - U/UTP - AWG24)
see Annex A
Each Rem is identifi ed by Rbm84 through
progressive sequential numbering (1 to 60)
regardless of the position along the path of
the connection cable; such number (also
called address) must be set on the appro-
priate dip selector in the base Rem card.
(
INPUT OR OUTPUT CAN BE CONNECTED TO TERMINAL BLOCK
* the sum of the Rem and/or Turnstiles that are serial connected along the
segment A+B must be at most 60 units
RBM84 - Hardware and connections
RBM 84
to successive Rem or Turnstile *
Two SEGMENT connection: RBM84 can be
located in any position along the cable route
from the fi rst to the last Rem/Turnstile,
maximum distance must be 1000 m
1 2)
OR
to successive Rem or Turnstile *
(
INPUT OR OUTPUT CAN BE CONNECTED TO TERMINAL
15
NOT INCLUDED
Cable
recommended type:
unshielded
multipair cable
(CAT 5 - U/UTP - AWG24)
see Annex A
1 2)
BLOCK OR