Manufacturer's Warranty - Hilti TE 800 Mode D'emploi

Trouble or fault
The tool does not
achieve full power.
The chisel cannot
be released from the
chuck.
9 Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as
household waste!
10

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about
the warranty conditions.
14 English
Printed: 08.07.2019 | Doc-Nr: PUB / 5210095 / 000 / 03
Possible cause
The extension cord is
too long or its gauge is
inadequate.
The voltage provided by
the electric supply is too
low.
The chuck is not pulled
back fully.
Action to be taken
▶ Use an extension cord
with an adequate con-
ductor cross section.
(1.5 mm² for lengths
up to 40 m; 2.5 mm²
for lengths up to 65
m).
▶ Connect the power
tool to a different
electric supply.
▶ Pull the chuck back
as far as it will go and
remove the accessory
tool.
2064796
*2064796*