Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Trouble or fault
The power tool
doesn't start.
The power tool
starts and the
service indicator
lights red.
The tool does not
achieve full power.
*2064796*
Printed: 08.07.2019 | Doc-Nr: PUB / 5210095 / 000 / 03
Possible cause
Electronics initialization
in progress (takes up
to 1 second after plug-
ging in) or the electronic
restart safety interlock
has been activated af-
ter an interruption in the
electric supply.
Interruption in the elec-
tric supply.
The supply cord or plug
is defective.
The control switch is
defective.
Generator in sleep mode ▶ Apply a load to
The service indicator
lights.
Power reduction is ac-
tive.
2064796
Action to be taken
▶ Switch the power tool
off and then on again.
▶ Plug in another power
tool or appliance
and check whether it
works.
▶ Have the parts
checked by a trained
electrical specialist
and replaced if
necessary.
▶ Have the power tool
checked by a trained
electrical special-
ist and the carbon
brushes replaced if
necessary.
the generator by
connecting a second
power consumer (e.g.
worklight).
▶ Have the power tool
serviced or repaired
by Hilti Service.
▶ Press the power
level selector switch
(observe the power
level indicator). Switch
the power tool off and
then on again.
English
13
Publicité
Table des Matières
