Symbols On The Product; Product Information; Declaration Of Conformity - Hilti TE 800 Mode D'emploi

These numbers refer to the corresponding illustrations found at the
beginning of these operating instructions
The numbering reflects the sequence of operations shown in the
illustrations and may deviate from the steps described in the text
Item reference numbers are used in the overview illustrations and
refer to the numbers used in the product overview section
This symbol is intended to draw special attention to certain points
when handling the product.
1.3 Product-dependent symbols

1.3.1 Symbols on the product

The following symbols are used on the product:
Service indicator
Power selector

1.4 Product information

Hilti products are designed for professional use and may be operated,
serviced and maintained only by trained, authorized personnel.
personnel must be specifically informed about the possible hazards. The
product and its ancillary equipment can present hazards if used incorrectly
by untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to inquire about the product.
Product information
Breaker
Generation
Serial no.

1.5 Declaration of conformity

We declare, on our sole responsibility, that the product described here
complies with the applicable directives and standards.
declaration issued by the certification department can be found at the end
of this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | 86916
Kaufering, Germany
2 English
Printed: 08.07.2019 | Doc-Nr: PUB / 5210095 / 000 / 03
TE 800-AVR
01
A copy of the
2064796
*2064796*
This