Metz mecablitz 64 AF-1 digital Mode D'emploi page 163

Set number of flashes (N)
STROBO • Press the sensor button for the number of
flashes
M-
3.1m
m
35
Zoom
m
5 10
N f(Hz)
P
1/16
• Press the
O
N
touch display and select the desired num-
3 ber of flashes.
4
5
p
q
+
The maximum possible number of flashes
(N) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired number of flashes
(in the example
The setting will take effect immediately.
N
on the touch display.
sensor buttons on the
4
.
Setting the flash frequency (f(Hz))
STROBO
• Press the sensor button on the touch
display for the flash frequency
M-
3.1m
m
35
Zoom
m
4 10
N f(Hz)
P
1/16
f (Hz) O
• Press the
touch display and select the desired fre-
7
quency of flashes.
8
9
p
q
+
The maximum possible frequency of flashes
(f) depends on the set partial light output
(P).
• Press the sensor button on the touch
display for the desired frequency of flashes
in the example
The setting will take effect immediately.
STROBO
The valid distance to the set parameters is
M-
shown on the display.
3.1m
m
35
Zoom
m
The distance value displayed can be adjusted
4 8
N f(Hz)
to the distance from the subject by changing
P the f-stop or the partial light output.
1/8
The aperture and ISO values are not shown
on the display in Strobe flash mode!
+
The secondary reflector is not supported in
stroboscopic flash mode.
f (Hz)
.
sensor buttons on the
k
8
.
163