Sealed Burners; Burner Caps; Cooktop Operation; Grates - Bosch NGT73 Mode D'emploi

The following pages explain how each feature on the
gas cooktop works and how to get the best cooking
results.
Follow these hints when cooking on the cooktop:
• Use proper cookware. (See Page 6.)
• Center the pan over the burner before turning the
burner on.
• Refer to the Cooking Chart on Page 7 for suggested
flame settings.

Sealed Burners

Your new cooktop has sealed gas burners. There are
no burner parts under the cooktop to clean, disassemble
or adjust. Your cooktop has two different burner cap
sizes, large and medium. Match the pan to the size burner.

Burner Caps

Enamel Burner Cap
Burner Base
The burner cap is porcelainized steel. On the under-
side of the cap is one locator which must fit into the
corresponding notch on the burner base. If the burner
cap is not placed correctly, the burner may not light or the
flame may not burn completely or correctly.
WARNING: To prevent flare-ups do not
!
use the cooktop without all burner caps
and all burner grates properly positioned.

COOKTOP OPERATION

Porcelain
Notch
Burner Grates
The position of each double grate is labeled on the
underside edge of the grate as shown in the figure below.
Universal
(30" models only)
30" Models have two universal grates. Position the
straight side in the center. They are interchangeable by
rotating 180°.
36" Models have one side grate, one center grate and
one single grate. Position the grates on the cooktop as
illustrated above.
WARNING:To prevent flare-ups all
grates must be properly positioned on the
!
cooktop whenever the cooktop is in use.
Each of the four feet must be placed into
the corresponding dimples in the cooktop.
See illustration on Page 8. Do not use a grate
if the rubber feet are missing or damaged.

Burner Control Knobs

OFF
Locator
HI
STANDARD BURNER CONTROL
PAGE 4
Center
Side
Knob Indicator Line
Control
Knob
LO
Single
(36"
models
only)
.