Setting Procedure For The Electric Grill; Cleaning The Accessories; Setting The Hob; Advance Cleaning Of Burner Cup And Cap - Bosch HGA33A150S Notice D'utilisation

Setting procedure for the electric grill

Open the top cover. The top cover must remain open for as
1.
long as the oven is in operation.
Open the main gas supply to the appliance. Connect the plug
2.
in the socket.
Press the multi-function button. The electric grill and rotary
3.
spit are switched on at the same time when you press the
multi-function button. The oven light comes on

Setting the hob

Your hob is equipped with three gas burners and one hotplate.
The following information explains how to light the gas burners
and set the hotplate.

Advance cleaning of burner cup and cap

Clean the burner cap (1) and cup (2) with water and washing-
up liquid. Dry the individual parts carefully.
Place the burner cup and cap back on the burner shell (5).
Ensure that the igniter (3) and flame safety pin (4) are not
damaged.
The nozzle (6) must be dry and clean. Always position the
burner cap exactly over the burner cup.

Igniting the gas burners

Always position the burner cap exactly onto the burner cup. The
openings in the burner cup must remain unobstructed at all
times. All parts must be dry.
Open the upper cooker cover. The upper cover must remain
1.
open whilst the cooker is in operation.
Turn the control for the required hotplate anti-clockwise to the
2.
symbol with the large flame
With the hotplate control pressed in, press the ignition button.
3.
Gas begins to flow out and the gas burner ignites.
.
—
Turn the switch for the electric grill clockwise to
4.
Turn off the switch for the electric grill after 30 minutes. Turn
5.
off the multi-function button.

Cleaning the accessories

Before you use the accessories for the first time, clean them
thoroughly with hot soapy water and a soft dish cloth.
Press and hold the hotplate control for 1-3 seconds. This
4.
activates the safety pilot. If the gas flame goes out, the gas
supply is automatically cut off by the safety pilot.
Set the required flame size. Between the Off
5.
setting, the flame is not stable. Therefore, always choose a
—
setting between the large flame
If the flame goes out again, repeat the process from step 2.
6.
To finish cooking, turn the hotplate control clockwise to the
7.
Off position.
û
The hotplate control should not be turned to the ignition
position for longer than 15 seconds. If the burner does not light
within 15 seconds, wait at least one minute. Then repeat the
ignition process.
The gas burner does not ignite
If there is a power cut or if the ignition plugs are damp, you can
light the gas burners with a gas lighter or a match.

Electric hob

Electric hob, Heat capacity
heat settings
1 100 W
2 150 W
3 220 W
4 500 W
5 720 W
6 1000 W
.
(
setting and the
û
and small flame .
— ˜
Suitable pot or pan diam-
eter for the electric hob
14.5 cm
14.5 cm
14.5 cm
14.5 cm
14.5 cm
14.5 cm
33