Hydraulic Installation; Electrical Installation; Hydraulic Motor - Vetus BOW410HM Manuel D'utilisation Et Instructions D'installation

Hydraulic installation

Consult the installation manual 'Vetus Power Hydraulics,
Hydraulic installation (art. code I.HT01).

Electrical installation

Consult the installation manual 'Vetus Power Hydraulics,
Electrical installation (art. code I.HT03).
Maintenance
Check the cathodic protection and if necessary renew the zinc
anode.
There is a spare part set, including a zinc anode, available.
Art. code: SET0075.
Clean the propeller shaft, grease with 'outboard gear grease'
and refit the propeller on the shaft.

Hydraulic motor

The hydraulic motor requires no specific maintenance
Operation manual and installation instructions Hydraulic bow thruster 410/ 550 kgf, ø 400 mm
Trouble shooting
Hydraulic motor rotates (too) slowly.
- Speed of the hydraulic pump is (too) low.
Hydraulic motor does not rotate at all.
- Check whether the main switch is in position 'ON'.
- Check whether the control circuit fuse is blown. Control cir-
cuit is shortened, check wiring.
- Transmission of the hydraulic pump is faulty.
The hydraulic system looses oil.
- Check all tubing and connections for possible leakage.
SET0075
ENGLISH
15
12.0202