Final Assembly - Vetus BOW410HM Manuel D'utilisation Et Instructions D'installation

Installation of tail piece
Remove the propeller.
Install the gasket between the tail piece and the thrust tunnel.
Apply a sealant (polyurethane* or silicon), and position the tail
piece into the hole in the thrust tunnel.
Mount the adapter flange on the tail piece. Grease the threads
of the bolts with 'outboard gear grease' before before mounting
them.
*) e.g. Sikaflex ® -292.
Check for possible leaks immediately the ship returns to
water.
14
12.0202

Final assembly

3-12300-3b
Make sure that the key (1) is properly positioned in the keyway
of the shaft.
Grease the shaft with 'outboard gear grease' and install the pro-
peller (2) with the O-ring (3) and the hexagonal nut (4).
Secure the nut with the lock-screw (5). Fit the zinc anode (6) to
the propeller shaft by means of the bolt (7).
The propeller should be at
least 1.5 mm free of the
thrust tube wall, all round.
Fit the connections in the tail piece.
Operation manual and installation instructions Hydraulic bow thruster 410/ 550 kgf, ø 400 mm
1
2
3
5
6 7
4